Categories:

Frigidaire Front-Load Washer Leaking? Drain Pump #137221600

back of the top

ifixappliance.ca encourages you to perform this procedure safely in this article we will explain one or more of these icons to alert you when to use caution as with any repair be sure you’ve unplugged the appliance before beginning your first step is to remove the screws at the back of the top panel and pull the panel off next pull out the dispenser drawer and depress the tab near the back to release it remove the housing screws as well as the control panel screws on top now depress the tabs to release the control panel and move it out of the way use needle nose pliers to remove the wire clamp and spring and peel the boot seal off the lip of the front panel carefully lift the washer up and support it with the wood block or comparable sturdy object this will allow you to remove the screws from the bottom of the front panel set the washer back down and remove the screws at the top of the panel now lift the panel up and out to detach disconnect the front panel wire harness and set the panel aside reach under the tub and release the clamp to detach the inlet sump hose be prepared for some water to spill out release the clamp to detach the drain hose and disconnect the wire harness remove the mounting screws to release the old drain pump install the new drain pump by positioning it and securing the mounting screws reconnect the wire harness reattach the drain hose and secure it with the clamp reattach the inlet sump hose and secure the clamp reconnect the front panel wire harness and reposition the panel by aligning the holes in the panel with the nylon pins on the frame replace the screws at the top of the panel lift and support the washer then replace the screws at the bottom of the front panel set the washer back down realign the boot seal with the front panel and secure it with the wire clamp in spring reposition the control panel and snap it into place replaced the screws on top as well as in the dispenser drawer housing reinstall the dispenser drawer reposition the top panel and security with the screws you’re now ready to plug the appliance back in to make sure it’s functioning properly

the top of the panel
needle nose pliers